Replenishment Chemicals and Anodes

Aluminum Degreaser Powder - 2lb Makes 3 Gallons

This special degreaser for Aluminum quickly cleans any aluminum alloy without etching. Mix 2 lbs of cleaner with 3 gallons of distilled water in a stainless steel container. Heat to 130 deg F on a hotplate. Immerse aluminum parts for 3-10 minutes prior...

ANODE BANDAGE

Wraps around anode

CHEMICAL MIST SUPPRESSANT (For Chrome Plating)

A chemical frothy blanket that actually floats on top of the chrome, virtually eliminates all misting when used with Fume Control Balls. Use one bottle per 2 sq ft of plating tank surface area.Note: Mist Suppressant is now premixed into our chrome...

COPPER ANODE .032" x 4"x 8"

Copper Anode 4" x 8"

COPPER BRIGHTENER PART A - 1.5 OZ

Treat 1.5 gallons. Add when making up copper solution for the first time.

COPPER CRYSTALS W/BRIGHTENER 1.5 GAL

Add 1 Bag Copper Crystals to 176 fl oz distilled water.Add 16 fl oz Battery AcidAdd 1.5 fl oz Copper Brightener A and 0.3 fl oz Copper Brightener B.Plate a piece of scrap brass or copper for approx 1 hour at required current (0.07 amps per square inch)

COPPER CRYSTALS WITH BRIGHTENER 10 Gallons - 16.5 lbs

Makes 10 Gallons Acid Copper Plating Solution Add to: 106 fl oz Battery Acid 9.2 Gallons Distilled Water 10 fl oz Copper Brightener A 2 fl oz Copper Brightener B

COPPER CRYSTALS WITH BRIGHTENER 20 Gal - 33 lbs

Makes 20 Gallons of Acid Copper Plating Solution Add to 213 fl oz Battery Acid 18.3 Gal Distilled Water 20 fl oz Copper Brightener A 4 fl oz Copper Brightener B Plate a piece of scrap brass or copper for approx 1 hour at required current (0.07 amps per...

COPY CHROME ANODE 6" X 6"

Pure Cobalt Anode 6"x6"

COPY CHROME CRYSTALS W/BRIGHT - 1.5 GAL

Mix this bag with 1.5 Gals of Distilled Water. Add 16 fl oz brightener.Refer to plating manual for plating instructions.  

DECORATIVE CHROME CRYSTALS - 10.5GALS

READ MSDS BEFORE OPENINGMix with 1.5 Gal distilled water and one 6 fl oz bottle of Chrome Plating Catalyst.

Deoxidizer/Desmut - 1 Quart

1 Quart mixes with 2 gallons of water. Use to minimize smutting of aluminum parts before anodizing or plating. Use at 70-110 deg F, for 1-3 minutes. Contains Hazardous Goods. Shipping restrictions apply. Ground shipping only to the Continental USA...

FLASH COPPER PART B - 1 PT

Flash Copper Solution Part B - 1 Pint

FLASH COPPER PART C - 1PT (LTD-QTY)

Flash Copper Solution Part C - 1 Pint

FLASH COPPER SOLUTION PART A - 1 GAL

Flash Copper Solution Part A - 1 Gal