| Low
speed 1100RPM Buffing Machine is ideally suited for
polishing wood, acrylic, lacquered surfaces, plastics
and more. Perfect for guitar polishing!
Kit includes:
- 1100RPM, 3/4 HP Buffing Machine
- 6 x 12" diameter acrylic buffing wheels
- 1 x Plastic Buffing Compound (Fine)
- 1 x Plastic-Glo Buffing Compound (Ultra-Fine)
- 5 each 120, 240, 400 and 600 grit Wet and Dry
Paper
- Wheel Rake
- Instructions
Instructions:
If the object to be polished has heavy scratches,
start by sanding. Start with 120 grit sandpaper, used
dry. Switch to a 240 grit paper, dry. Finish with
the 400 grit paper, used wet. Grits as fine
as 600 may be used. Always use a wooden or rubber
sanding block (not supplied). When removing scratches
be sure to sand an area larger than the scratch. Sand
with a circular motion, and use a light touch and plenty
of water when using paper wet.
Polishing with the buffer will bring the surface a
high lustre. Start with the Plastic Buffing Compound
(Fine), and then switch to the Plastic-Glo Buffing
Compound (Ultra-Fine). Be careful not to apply too
much pressure, or excessive heat may cause burning
of the part. Dedicate a buffing wheel for each compound,
to avoid cross-contamination and introducing scratches
into your final polish.
The buffing machine features large
diameter, extended shafts, allowing easy access of
larger parts. Heavy duty cast iron base and frame.
Precision machined shaft and lubricated bearings for
longer life. Single phase motor. May be mounted to
a bench, or for greater access, to the optional stand.
- 3/4 HP, 115V, 60 Hz, 7.8 amps
- 1100 RPM
- Spindle thread: 3/4'' x 12 TPI
- Spindle length: 2-5/16''
- Base: 8''L x 5-3/4''
- Overall length of shaft - 30"
- Height of shaft center from bottom of base - 6.5"
- 12 month warranty
Buffing Machine Stand
|
