| The Diamondite Clear Vinyl Kit for Hand Application includes:
- 4 oz. Clear Vinyl Stain Reducer
- 4 oz. Clear Vinyl Cleanser
- 4 oz. Clear Vinyl Shield
- 1 Microfiber Applicator
- 1 Tri-color foam applicator
- 16 x 16 inch Cobra Microfiber Towel
- Instructions
Clear Vinyl Stain Reducer
Diamondite Clear Vinyl Stain Reducer removes stains and yellowing to restore the clear, clean shine of soft vinyl windows. Just spray it on and watch discoloration vanish. There’s no faster, easier way to restore the like-new appearance of soft, clear vinyl windows on convertible tops and soft-top Jeeps.
The solvent in Clear Vinyl Stain Reducer starts removing the yellow film and stains on contact. The cleaner is completely safe on the vinyl and does not strip the remaining plasticizers. Dingy, yellow vinyl windows will clear up in seconds!
Note: The key to total restoration of vinyl windows is to catch the damage early. Vinyl that has cracked is beyond restoration.
Clear Vinyl Cleanser
Vinyl damage is often two-fold: it clouds and turns yellow. Even after Clear Vinyl Stain Reducer has removed discoloration, the vinyl may not be optically clear. That’s the job of Diamondite Clear Vinyl Cleanser. This nonabrasive cleanser gently polishes the vinyl to remove the remaining haze and restore the crystal clear visibility. Fine scratches will disappear, leaving smooth, clear vinyl once again.
Our chemist took the basic principle of a fine paint cleanser and built a formula that is exceedingly safe on soft vinyl. The cleansing lotion cleans without stripping the plasticizers and softening agents that keep the vinyl supple.
Diamondite Clear Vinyl Cleanser works well to remove haze from marine eisenglass, too. Even haze caused by salt spray can be removed in many cases, or at least greatly improved.
Clear Vinyl Shield
Protection is the key to maintain clear vinyl windows. Diamondite Clear Vinyl Shield is a water-based polymer formula that defends vinyl against the ravages of UV rays, water, and pollution.
Oil-based products tend to streak clear vinyl. Diamondite Clear Vinyl Shield is water-based to create a perfectly transparent, protective barrier between the vinyl and the environment. This is a crucial part of maintaining the vinyl because any factory top coat has already diminished.
Instructions
Before you begin…
Tape off the area surrounding the vinyl using painter’s tape. Clean off any loose debris with a damp microfiber towel.
Step 1 – Clear Vinyl Stain Reducer
Spray the vinyl window generously with Diamondite Clear Vinyl Stain Remover. Wait 10 seconds for the cleaner to penetrate. Wipe the window dry with a soft microfiber towel. If some stains or yellowing are still present, perform a second application.
Step 2 – Clear Vinyl Cleanser
Dispense a quarter size amount of Diamondite Clear Vinyl Cleanser onto the white side of the Tri-color Foam Applicator. The white foam is polishing foam. Rub back and forth across the vinyl until the cleanser starts to dry. Buff with the included microfiber towel. If haze persists, repeat this step.
Vinyl weathering occurs on the outside only so there is no need to polish the inside of the window.
Step 3 – Clear Vinyl Shield
Mist the window with Diamondite Clear Vinyl Shield. Use a microfiber towel or applicator to spread the sealant over the vinyl. Flip and buff dry. After an hour, you can apply another coat for added protection.
Reapply Clear Vinyl Shield once a month to maintain the protection and shine. |
